Tappet Screw Plastic Ends with Metal End Cap x 1 for Mitsubishi FTO GPX GPvR 2.0 V6 Mivec engined models ONE SINGLE TAPPET SCREW END WITH METAL CAP (Picture Shows What you Get)
Order as many as you need (24 used on FTO Mivec Engine 12 per Cylinder Head) These can be a problem as the the plastic part goes brittle over time. Never figured if this is just aging, the plastic not being up to the job or the use of poor quality oil. But the plastic drops away and leaves the stainless steel end sitting between the screw and top of valve and under hard acceleration they can jump out. They 'usually' end up in the sump but the engine will now tap badly as the gap is now several mm and not nought point something ! Adjust to 0.1mm Inlet 0.13mm Exhaust Exploded Diagram HERE & Adjusting Instructions HERE Mitsubishi Part Numbers MD212099:ENDS Tappet Screw ENDS+ CAP ONLY MB991478 Feeler Gauge MB991477 Adjusting Tool/Socket
